Stone Care

Stone Care™ products are simple to use for any stone and tile surface such as marble tile, granite counter tops, ceramic tile, granite tile, floor tile, ceramic wall tile, ceramic floor tile, limestone, slate, terrazzo, porcelain tile, quarry tile and even Corian and Formica. SCI also has products for cleaning grout, polishing marble, removing stains, and restoring dull marble surfaces. Stone Care™ products are ideal for kitchen and bathroom use or every part of a home or building.

It is important to understand that generic neutral cleaners are different than neutral stone cleaners. Generic neutral cleaners are predominantly found in the janitorial industry and they are designed to mainly clean soft, nonporous surfaces such as floor waxes and coatings. They just clean the surface.

Cleaning Countertops

Cleaning: (Daily to Weekly)
Product:Marbamist®

  • Simply spray Marbamist on to the stone surface.
  • Wipe off the cleaner with a clean and dry terry cloth or paper towel.

Sealing: (Every 1-2 years)
Product: Stone Spray-N-Seal®

  1. Surface should be dry for 6-12 hours before sealing.
  2. Clean countertop surface using Marbamist or Clean EnCounters. For stone floors, clean with Marbalex. (It is safe to lightly clean the stone before sealing.)
  3. Cover surrounding areas that are not intended to be sealed.
  4. Liberally spray the entire surface until it is wet. (Outer edges may dry quicker.)
  5. When surface begins to dry within 3-5 minutes, wet the surface again with the sealer. (This will allow the sealer to properly penetrate and cure.)
  6. After 30 minutes, wipes off excess sealer from the surface with a clean and dry white terry cloth towel.
  7. If excess dries on the surface, spray more sealer onto the surface and wipe off immediately with a clean dry terry cloth towel. For large stone floors, excess can be buffed off with a clean white buffing pad or an all cloth bonnet pad.
stnstand

Cleaning: (Daily to Weekly)
Product: Marbamist®

  • Simply spray Marbamist on to the stone surface.
  • Wipe off the cleaner with a clean and dry terry cloth or paper towel.

STAIN REMOVAL: (As Needed)
Product: Stone Spray-N-Seal®,FPP Stain Remover

  • Identify the type of stain and select the correct SCI Poultice Powder.
  • Clean area first with distilled water.
  • Mix the pultice with water to create a thick peanut butter consistency.
  • Apply the poultice over the stained area only.
  • Cover the paste with plastic wrap.
  • Put a few pin holes in the plastic wrap.
  • Once the paste has hardened, remove the plastic wrap.
  • Gently remove the dried paste with a plastic scraper.
  • Reseal area with Stone Spray-N-Seal.
spnseal
foodstain
oilstrem
marbamist

These extra absorbent poultice powders are designed to reabsorb stubborn stains out of stone that cannot be removed with liquid cleaners. There are five ready to use formulas. Each formula is designed to remove a specific stain: Rust, oil, food, mildew, and ink.